Engraving of a LAMY Studio in pink matt

One of the most beautiful LAMY fountain pens. Due to its beefy shape, stainless steel, high-quality paint and metal handle, it fits very well in the hand.

It becomes even more personal with an individual engraving. Due to the special shape and the clamp on the casing, this is only possible in the area of the pen shaft. You can engrave the pen shaft both at the top and bottom, which gives more space for individual messages.

LAMY Studio Pink matt

Technical parameters of engraving

Material: Lamy studio matt lacquered stainless steel
Color: pink matt lacquer on stainless steel
Power: 40 (provides the best result)
Speed: 20
khz: 25
Passages: 1
Focus shift: 0
Air cooling: 0
Mode: Grid
Laser: CO2
Resolution: 600 DPI (provides the best result)
Font: Kristin ITC
Duration: 18 seconds

Notes:
Engraving a round fountain pen requires a rolling device. Since the shaft alone is too short and the laser head runs the risk of colliding with the clamping device, we extend the working area with a sharpened dowel rod.

We mark the area of the fountain pen to be engraved with painter's tape and two lines at each end of the pen. This means we can even measure the upper area of the fountain pen barrel (similar to the nib) and the lower area (similar to the ink pipe) for engraving.

With the Lamy Studio it has proven to be a good idea not to set the energy so high because the color of the filler can be removed quite easily. A higher energy density would not make the engraving better, but could cause the paint to look burnt at the edge of the engraving.

A medium DPI and slow speed ensure a clean engraving image and sharp edges.